i purchased a new CCTV digital camera protection technique from ebay and i experimented with turning on the dvr on today i plugged anything in like in the directions but when i try to see the DVR on a observe or Tv it says no signal i tried vga and video clip output and all the screens say no signal it is a 320 gb DVR make sure you help me ?????????????????????????????????????
Greatest response:
Response by A T
A number of things to verify out.
1st, make positive your keep track of is plugged into a composite output, or your keep an eye on is plugged into the VGA output. DVR's have tons of inputs/outputs and it really is easy to get them combined up.
The 2nd factor to validate is that the DVR setup is set to output to the acceptable port. Occasionally you need to do a software program setup and reboot to get the output going.
Very last point to do is verify the cable - it could be a poor 1!
Hope this helps
Large Brother http://www.securitycameratutor.com
What do you believe? Solution below!
No comments:
Post a Comment